Fuel pump bridge
-
- Full Member
- Posts: 106
- Joined: Mon Feb 14, 2022 10:55 am
- Location: Yeovil, Somerset
- Has thanked: 1 time
- Been thanked: 3 times
Fuel pump bridge
When bridging the fuel pump and ground on the diagnostics near battery the fuel pump turns on and relay clicks. Without bridge fuel pump does not turn on. Where to go next?
-
- Site Admin
- Posts: 3466
- Joined: Thu Sep 06, 2018 6:08 pm
- Location: South Norfolk
- Has thanked: 62 times
- Been thanked: 91 times
Re: Fuel pump bridge
I would be checking the black wires at the back of the immobiliser and the fuel cut off switch, the terminal corrode
Admin and Owner of this fine club 
Location : South Norfolk
Location : South Norfolk
Re: Fuel pump bridge
Yes, if the engine turns over when you turn the ignition key ,then the relay should 'click' , just like when you bridged the terminals in the diagnostics box
and the pump will run.
Problem is , if you have six black wires coming out of the immobilser and someone has connected them wrongly.
and the pump will run.
Problem is , if you have six black wires coming out of the immobilser and someone has connected them wrongly.
-
- Tech Rep
- Posts: 2877
- Joined: Fri Sep 07, 2018 8:28 am
- Location: chatham/kent
- Has thanked: 15 times
- Been thanked: 88 times
Re: Fuel pump bridge
AS said check the wires on the Moby block connector as seems to be inhibited,when you linked the diag box
out did you also check to see if fuel was comming out from fuel filter into the fuel rail
out did you also check to see if fuel was comming out from fuel filter into the fuel rail
Who is online
Users browsing this forum: No registered users and 32 guests