For all technical questions. VIEWABLE without login, you need to register (free) to be able to post a question.
-
CharlesUK
- Full Member
- Posts: 117
- Joined: Mon Feb 14, 2022 10:55 am
- Location: Yeovil, Somerset
- Has thanked: 2 times
- Been thanked: 4 times
Post
by CharlesUK » Wed Jul 23, 2025 12:53 pm
I have previously used a breakout fuse wired in place of rear wiper fuse, wire into cheap circuit timer and then a t5 bulb holder, airbag light comes on at ignition and after a few seconds goes out.
-
Trism
- Registered User
- Posts: 27
- Joined: Fri Jun 17, 2022 1:31 pm
- Has thanked: 1 time
- Been thanked: 3 times
Post
by Trism » Fri Jul 25, 2025 11:45 am
Ok if you have a chipped key car you can run a small wire from the back of the bulb from the ‘key’ bulb to the airbag bulb and it comes on once on startup as it should do
Air bag module beeps so just unsolder (or snap off) the piezo beeper, and now looks all good
-
Kit
- Tech Rep
- Posts: 3628
- Joined: Fri Sep 07, 2018 8:16 pm
- Location: Vange, Basildon
- Has thanked: 75 times
- Been thanked: 118 times
Post
by Kit » Fri Jul 25, 2025 9:11 pm
Trism wrote: ↑Fri Jul 25, 2025 11:45 am
Ok if you have a chipped key car you can run a small wire from the back of the bulb from the ‘key’ bulb to the airbag bulb and it comes on once on startup as it should do
Air bag module beeps so just unsolder (or snap off) the piezo beeper, and now looks all good
Please do a full write up with photos, send it to admin, so it can posted in the Oracle, so it would would help other members whom have this issue
Kit
Who is online
Users browsing this forum: No registered users and 76 guests