Page 1 of 1

Coolant filler cap

Posted: Wed May 22, 2019 12:24 pm
by Bikergonebald
Does anyone know where I can get a coolant filler cap? The one for the top of the engine that doesn’t have the pressure release spring.

Mine got fried when the engine overheated. If I can’t get a new one does anyone know where I can get an old one to modify and put a new seal in it?

Thanks
Kevin
Image

Re: Coolant filler cap

Posted: Wed May 22, 2019 12:47 pm
by mojo98
yes i get mine from Australia, then a Mazda dealer may be able to get one, but dont tell them its for a probe, (find a MX6 Reg number) just in case they ask what car its for :D

Re: Coolant filler cap

Posted: Wed May 22, 2019 1:14 pm
by Micron
Bikergonebald wrote:
Wed May 22, 2019 12:24 pm
Does anyone know where I can get a coolant filler cap? The one for the top of the engine that doesn’t have the pressure release spring.

Mine got fried when the engine overheated. If I can’t get a new one does anyone know where I can get an old one to modify and put a new seal in it?

Thanks
Kevin
Image
The one for the top never did have a pressure spring, but you can fit one if you like.

Re: Coolant filler cap

Posted: Wed May 22, 2019 1:22 pm
by Bikergonebald
I’m not intending to fit a pressure spring I just need a standard cap with a good seal.
I did try the spring type, it fitted but was loose and didn’t make a seal.

Re: Coolant filler cap

Posted: Wed May 22, 2019 1:27 pm
by Micron
Bikergonebald wrote:
Wed May 22, 2019 1:22 pm
I’m not intending to fit a pressure spring I just need a standard cap with a good seal.
I did try the spring type, it fitted but was loose and didn’t make a seal.
Ah I see, i misread your post.

Follow what malcolm said then.

There are a couple of MX6's on Ebay at present that you could get the reg number from just in case 8-)

Re: Coolant filler cap

Posted: Wed May 22, 2019 4:23 pm
by mojo98
This is what your looking for
Image

Image


just purchased 4 from Australia

Re: Coolant filler cap

Posted: Wed May 22, 2019 6:04 pm
by jrh
That rubber seal under the cap is actually a removable 'washer'.
Just pull at the outside and you will see it stretch over that centre piece.
Now go find an old bicycle inner tube and make yourself a new one.
ALWAYS smear the faces with Silicone grease to stop it sticking and tearing.
Job done, you're up and running again.

Re: Coolant filler cap

Posted: Wed May 22, 2019 9:01 pm
by Bikergonebald
Great thanks, I will try that.

Since mojo98 posted the pics of the Australian cap I’ve found out that a lot of big Nissans use the same cap including a Navara 2.5d and those caps seem to be listed in the uk.

If I found out for sure I will let everyone know.