Camber Caster specs

For all technical questions. VIEWABLE without login, you need to register (free) to be able to post a question.
Post Reply
fanman
Full Member
Posts: 137
Joined: Fri Sep 14, 2018 10:05 am
Has thanked: 2 times
Been thanked: 6 times

Camber Caster specs

Post by fanman » Wed May 22, 2024 7:09 pm

Having wheel alignment done tomorrow - does anyone have the camber and caster specs?
The oracle has specs for MX6 and 626 - is one of these the same as Probe?
Toe in is quoted 3mm +/- 3mm - I assume this is for TOTAL toe in not per wheel?
Any advice will be appreciated greatly,. :D

mojo98
Tech Rep
Posts: 2624
Joined: Thu Sep 06, 2018 10:52 pm
Has thanked: 41 times
Been thanked: 55 times

Re: Camber Caster specs

Post by mojo98 » Wed May 22, 2024 8:20 pm

Here is a page from my ford probe mtce manual


Image


hope this helps

fanman
Full Member
Posts: 137
Joined: Fri Sep 14, 2018 10:05 am
Has thanked: 2 times
Been thanked: 6 times

Re: Camber Caster specs

Post by fanman » Wed May 22, 2024 10:54 pm

Perfick!!!! Just what I needed !
Thanks so much - really appreciate you taking time to get this for me :D

mojo98
Tech Rep
Posts: 2624
Joined: Thu Sep 06, 2018 10:52 pm
Has thanked: 41 times
Been thanked: 55 times

Re: Camber Caster specs

Post by mojo98 » Thu May 23, 2024 4:05 pm

fanman wrote:
Wed May 22, 2024 10:54 pm
Perfick!!!! Just what I needed !
Thanks so much - really appreciate you taking time to get this for me :D
No Problems at all, that`s what this club is about, helping each other

Post Reply

Who is online

Users browsing this forum: No registered users and 8 guests