Page 1 of 1

Engine won’t start / no spark.

Posted: Thu Oct 10, 2019 2:25 pm
by LCP
The car started no problem and then just cut out after driving about 30feet, after which it will not start again.

So far:
Distributor has been replaced and tested.
Crank Sensor has been replaced and tested.
PCM has been replaced.

There is correct voltage going to distributor/ignition coil, but nothing coming out. There is also plenty of fuel getting through

Car is 94/95 2.5v6 gt

Re: Engine won’t start / no spark.

Posted: Thu Oct 10, 2019 2:46 pm
by Incognito
Has the factory fitted immobiliser been bypassed?

Re: Engine won’t start / no spark.

Posted: Thu Oct 10, 2019 2:47 pm
by Micron
Incognito wrote:
Thu Oct 10, 2019 2:46 pm
Has the factory fitted immobiliser been bypassed?
if it is an early car

Re: Engine won’t start / no spark.

Posted: Thu Oct 10, 2019 2:51 pm
by mojo98
looks to me that its a early car 94/95

Re: Engine won’t start / no spark.

Posted: Thu Oct 10, 2019 3:04 pm
by Micron
mojo98 wrote:
Thu Oct 10, 2019 2:51 pm
looks to me that its a early car 94/95
good spot :lol: :lol:

Re: Engine won’t start / no spark.

Posted: Thu Oct 10, 2019 3:09 pm
by fanman
LCP wrote:
Thu Oct 10, 2019 2:25 pm
The car started no problem and then just cut out after driving about 30feet, after which it will not start again.

So far:
Distributor has been replaced and tested.
Crank Sensor has been replaced and tested.
PCM has been replaced.

There is correct voltage going to distributor/ignition coil, but nothing coming out. There is also plenty of fuel getting through

Car is 94/95 2.5v6 gt
Sounds like the dizzy to me. Is the replacement dizzy new? How did you test it? If resistance in the coils is within spec then it points to the big transistor in the ignition module inside the coil having gone bad....

Re: Engine won’t start / no spark.

Posted: Thu Oct 10, 2019 8:18 pm
by LCP
Immobiliser has been removed.
Replacement Dizzy is new, and all coil resistances are within spec.

Re: Engine won’t start / no spark.

Posted: Fri Oct 11, 2019 7:56 am
by cpt black
I would re check the bypass for loose wire,does it have after market
alarm/immobiliser on it as theres only 3 circuits to shut the car down

Re: Engine won’t start / no spark.

Posted: Fri Oct 11, 2019 1:46 pm
by LCP
Thanks. I would if I could find them. However the immobiliser appears to have been totally removed. (All I can find are the bolt holes that the cage attached to)

Re: Engine won’t start / no spark.

Posted: Mon Oct 14, 2019 3:55 pm
by cpt black
You should find 2 plugs with all black wires and 3 pairs should be linked
check the links are still intact