UKPOC forums

OBD 1, there is no 'reader' you need to get an LED and bit of wire, info readily available online.

There are a lot of wires and pipes down the back of the engine they will have disturbed to do the job.

Look the the Crank Sensor Plug (down need dipstick), clean it up. Could be related.

Lots of incorrect fitments on ebay, probably assuming a Probe is the same as a Mondeo or something. Get the right one.

https://www.onlineautomotive.co.uk/mazd ... ius/fe466a

The ebay listings have the Klarius part number at the bottom, search those.

They are listed on ebay, just seen them now.

https://www.ebay.co.uk/itm/194300359768

https://www.ebay.co.uk/itm/144163315081

Probably find cheaper with a deeper search

The bearing in the accessory pulleys is a replaceable thing. Any bearing wholesaler would have them on the shelf.

DOT 4 absolutely.

Wasnt so bad, two bolts out of heat shield, bend it down, unhook and redo, jobs a goodun

Cable is stretched and part broken, I’ve adjusted the calipers correctly

Mine is all knackered, any tips to changing the front part? Does console need to come out?

Ok if you have a chipped key car you can run a small wire from the back of the bulb from the ‘key’ bulb to the airbag bulb and it comes on once on startup as it should do

Air bag module beeps so just unsolder (or snap off) the piezo beeper, and now looks all good

UKPOC forums

Search found 23 matches

Re: Engine cutting out

Re: Probe 16V MAF Sensor

Re: Exhaust for Ford Probe 24v

Re: Exhaust for Ford Probe 24v

Re: Pulley/bearing issue

Re: Brake fluid

Re: Front Hand Brake Cable

Re: Front Hand Brake Cable

Front Hand Brake Cable

Re: Air bag code 51