The advert is listed at GE, but wasn’t 100% sure as I believe that’s the year it crossed over. I have attached the link below.
https://www.ebay.co.uk/itm/156506570797
Search found 79 matches
- Mon Feb 03, 2025 10:09 pm
- Forum: The Garage - Technical Forum
- Topic: Rear shocks/ struts
- Replies: 3
- Views: 862
- Mon Feb 03, 2025 8:34 pm
- Forum: The Garage - Technical Forum
- Topic: Rear shocks/ struts
- Replies: 3
- Views: 862
Rear shocks/ struts
Hi all, Swapping previous owners coil overs back to original and can’t seem to get the strut into the knuckle. The coil over was lined up perfectly with it, but after putting the top studs through their mounting point this new strut seems to sit so far below the knuckle even after compressing the st...
- Mon Feb 03, 2025 2:23 pm
- Forum: The Garage - Technical Forum
- Topic: N/S drive shaft circlip
- Replies: 3
- Views: 1103
Re: N/S drive shaft circlip
Finally managed to beat it in, took shaking it around at the joint whilst friend hit from outer end with both hands. Even then still very tight!
- Sun Feb 02, 2025 6:51 pm
- Forum: The Garage - Technical Forum
- Topic: N/S drive shaft circlip
- Replies: 3
- Views: 1103
Re: N/S drive shaft circlip
Update: I have put the other end back into the wheel hub and attached the tie rods. It’s all fine on that end but the gearbox side is still like this, is it correctly seated? I I thought it might have gone in further
- Sun Feb 02, 2025 5:42 pm
- Forum: The Garage - Technical Forum
- Topic: N/S drive shaft circlip
- Replies: 3
- Views: 1103
N/S drive shaft circlip
Hi all, Changing nearside drive shaft, I have a replacement from J&R on eBay. I can’t get it back into the gearbox. When I take the circlip off the end its slides in effortlessly. But no matter how much I try I don’t think the clip lets is sit properly. I have attached a photo below of the join. htt...
- Sun Jan 12, 2025 4:55 pm
- Forum: The Garage - Technical Forum
- Topic: Seatbelt Pretensioner
- Replies: 2
- Views: 1992
Re: Seatbelt Pretensioner
I have tested the resistance on the crash sensors and have a resistance of 1181 on them. My knowledge of electrical circuits and testing is very limited. Is there any circuit to test under the seat relevant to the airbag system?
Charles
Charles
- Sun Jan 12, 2025 3:00 pm
- Forum: The Garage - Technical Forum
- Topic: Seatbelt Pretensioner
- Replies: 2
- Views: 1992
Seatbelt Pretensioner
HI, Still hunting for the cause of SRS code 13. I have tested the connector for what I believe to be the drivers seatbelt pretensioner (white clip under seat, not the one connecting to under carpet but strapped to the underside of the seat) and have a resistance of 0. I wanted to check the passenger...
- Sun Dec 22, 2024 8:10 pm
- Forum: The Garage - Technical Forum
- Topic: No hot air
- Replies: 16
- Views: 23645
- Sat Dec 21, 2024 3:58 pm
- Forum: The Garage - Technical Forum
- Topic: No hot air
- Replies: 16
- Views: 23645
Re: No hot air
Once again no hot air! Have been losing coolant throughout the year, but can’t seem to get hot air even after filling and letting run with cap off. Expect heater is blocked as when recirculating the air it slowly warms itself up meaning the heater setting is on? Where abouts can I find the heater? C...
- Wed Dec 04, 2024 8:26 pm
- Forum: The Garage - Technical Forum
- Topic: Copy key
- Replies: 12
- Views: 28655
Re: Copy key
Have attached photos of the entry fob, as well as my key.
Charles
Charles