UKPOC forums

Drove the car a “little past” the drive to see if it made a difference but sadly not Sounds like a plan! I will spend tomorrow morning checking leads and cleaning the sensors and get back to you. I’ll also disconnect and reconnect the bumper airbag sensors :) A lot of pressure as these 2 issues are ...

Thanks Admin :) I have only turned the car around on the drive as it’s not got an MOT yet, would that not be enough? Confused as to why would several working sensors flash up just from replacing disks and pads? As said I did not disconnect the sensors from the wheels. Everything is connect as before...

Hi, I’m trying to read the OBD1 ABS Flashes - how do you translate these into numbers? There’s long and short flashes and I can’t establish a break between them. No way to upload a video either but if someone wants to private message an email for me to send a clip. Also - The airbag light on the das...

Hope you can all forgive my recent hounding of the forum but I’m finally finishing up the build and left the head scratching stuff until last. So I’ve got a solid ABS light on followed by a flash Airbag light (flash 4 times) on the dash. No check Engine light. Recently I have replaced the front bump...

Ah the famous Denso tape, this wraps around the 4mm adjustment?

Update: callipers back together and handbrake all done with 4-5 clicks

thanks all

Interesting, when looking online I found a few variants of mechanism so wasn’t sure. Thanks for that

The handbrake now works I just need to correct the 15+ clicks to get it on the road

Ok so I think I’ve got it… Taken the nut/screw-in piece out as it had to be tapped into the piston, then screwed it into the resus. Issue was that it had to be tapped or pressed into the piston and was a tight fit. Seems to be working just need to follow prior posts to tighten the slack. Thanks agai...

Ok so it’s more of a push into the piston rather than screw/thread. There are no threads on the inside of the piston (image)

Hi, A difficult one to convey so I apologise for that Basically I want to know how far to seat/screw down this “nut” that I’ve labelled. I’ve drawn option 1 or option 2 (opt 2 being fully seat) Any confusion do let me know haha https://i.postimg.cc/KkjrHNSZ/IMG-0024.jpg https://i.postimg.cc/jLP6m29J...

Ok so back with hopefully some last questions after fluid pushing the piston out to change the seal. When reinstalling the brake piston, how far down do I thread the internal nut onto the threaded shaft/adjuster (see photo). Does the end of the thread need to touch the piston or do I need the nut fl...

UKPOC forums

Search found 32 matches

Re: Lights on dash - Abs and Airbag issue

Re: Lights on dash - Abs and Airbag issue

Re: Lights on dash - Abs and Airbag issue

Lights on dash - Abs and Airbag issue

Re: Rear calliper/handbrake rebuild

Re: Rear calliper/handbrake rebuild

Re: Rear calliper/handbrake rebuild

Re: Rear calliper/handbrake rebuild

Re: Rear calliper/handbrake rebuild

Re: Rear calliper/handbrake rebuild